Most of BinEdit's commands work on "the selection": the faces (or vertices) you've marked. In the old days you pressed Space until the face you wanted turned purple, then F to mark it green. You still can. But now you can just click.
There are two separate ideas here, just as before:
Press 3 for Face Select Mode (the default) or 1 for Vertex Select Mode. You can also use the Edit menu. The mode decides what a click, a hover or a box picks. Switching modes keeps both selections.
In vertex mode, the vertices you can see are drawn as dots: grey normally, orange when selected, cyan under the pointer.
| Do this | Face mode | Vertex mode |
| Click | Selects only that face and makes it current | Selects the nearest visible vertex (within 8 pixels) |
| Shift + click | Adds to the selection | Adds |
| Ctrl + click | Removes from the selection | Removes |
| Click empty space | Clears the selection | Clears |
As you move the mouse, the face (or vertex) a click would pick is outlined in cyan.
Drag on empty space in the 3D view to draw a box.
In Solid or Textured view, the box only takes faces you can actually see. Faces hidden behind others or facing away are left alone. In Wireframe it takes every front-facing face whose centre is inside the box, hidden or not.
On the Groups menu, and on the right-click menu:
| Command | Key | Does |
| Select Same Texture | Ctrl+T | Adds every face using a texture the selected faces use |
| Select Connected... | Ctrl+E | Adds faces joined by edges, stopping at creases sharper than the angle you give (default 40°; it remembers your last answer) |
| Grow Selection | Ctrl+Plus | Adds the ring of faces around the selection |
| Shrink Selection | Ctrl+Minus | Drops the faces at the edge of the selection |
These need at least one face selected to start from.
Also handy:
Right-click in the 3D view for Select Same Texture, Select Connected, Grow, Shrink, Set Group Material, Select All / Deselect All Faces and Delete Selected. If you right-click a face that isn't selected, it becomes the selection first. Right-clicking inside the selection keeps it.
Groups → Face Groups... (and Vertex Groups...) still let you name a selection and load it again later. Tick Add to current selection to combine groups.
| << Getting Around | Moving Things & Undo >> |