Joined: Thu May 25, 2000 2:01 pm
Posts: 135
Location: Chicago
|
|
Start yanking!
Your stuck here. The problem is both sides of the truck are mapped to the same spot on the raw. The good news is it dont involve the pallette.
The bad news is you need to remap the backward side. Find a spot on the raw or make a new file & paste a copy of the trucks side from the first raw. Erase the name, repaint it so the word run's in the right direction & remap the side in Binedit.
[This message has been edited by Jam-N-Jim (edited 28-03-2001).]
|
|
