can't use ZMODELER...

Downloads: www.mtm2.com/~mtmg/utilities.shtml
Post Reply
ZO_BigDOGGe
Member
Posts: 363
Joined: Mon Nov 20, 2000 2:01 pm
Location: Mountain View, Calif., USA

can't use ZMODELER...

Post by ZO_BigDOGGe »

-----------------------------------
I can't get ZMODELER to work...I get an error message that sez...

****** The 3DENGINE.DLL file is linked to missing export DDRAW.DLL ImageirectDrawCreateEx. *****


Any Ideas? I tried an older version of directX, since I have an older comp (pent1 233 mhz)

I tried updating all of the ZMODELER files I could, with no results. I currently have DirectX 6.1 installed...
Top
User avatar
Phineus
Glow Ball
Posts: 24
Joined: Tue Feb 02, 1999 7:00 pm

Post by Phineus »

I haven't had much success with zmodeller, but others have. Only thing I know for sure is that there is supposed to be an all-in-one zip available now. If you didn't install in one step, maybe you could try to find that file. Also, I'm using DX7a and I have that file in the windows\system folder. If you need it, I can send it over to you.
Top
ZO_BigDOGGe
Member
Posts: 363
Joined: Mon Nov 20, 2000 2:01 pm
Location: Mountain View, Calif., USA

Post by ZO_BigDOGGe »

Thanx, but I got it working, FINALLY!
I had to upgrade from DirectX 6.1 to 7.0 That did the trick! I got the newest version of Zmodeler too.... from this site
http://www.zmodeler.com
Top
User avatar
ch_2005
Member
Posts: 696
Joined: Thu Apr 19, 2001 2:01 pm
Location: USA and Proud of it.
Contact:
Contact ch_2005

Post by ch_2005 »

I used to have great luck w/ zmodeler but now that my hard drive chashed and i'm using a new one it hasnt been working so well. I'll try updating my Directx.

------------------
Visit my site
Top
Post Reply

Return to “Utility Talk”