checkpoint troubble plz help
-
phantomghs
checkpoint troubble plz help
ok heres the deal.. I'm trying to put in 6 check points. They all work but.. only the startline, and the last point makes a sound when you pass through.. For example, If I only use the startline(seguence 1), and the first check (sequence 0) They both make a sound when you pass through. However, if I add in a 3'd then only the start, and the last one makes a sound when passing through. and so on for the more I add the more I lose.. How can I fix this in traxx 1.4?
when you add checkpoints they sometimes get out of sequence therefore will not register at the proper time.
how to fix it.... go ahead and add all six checkpoints where you want them, now go to the first cp (not the start/finish line) and right click/properties, the sequence should be 0 if not change it to zero, now go to the second cp click on properties it should be set to 1 if not change it to one and so on so they are like this:
CP1 needs to be set to sequence 0
CP2 needs to be set to sequence 1
CP3 needs to be set to sequence 2
CP4 needs to be set to sequence 3
CP5 needs to be set to sequence 4
CP6 (start/finish) needs to be set to sequence 5
once you get them in order you'll be fine...
oh ya be sure all their object properties "type" is set to "checkpoint" also
[edit] more info on cp's
how to fix it.... go ahead and add all six checkpoints where you want them, now go to the first cp (not the start/finish line) and right click/properties, the sequence should be 0 if not change it to zero, now go to the second cp click on properties it should be set to 1 if not change it to one and so on so they are like this:
CP1 needs to be set to sequence 0
CP2 needs to be set to sequence 1
CP3 needs to be set to sequence 2
CP4 needs to be set to sequence 3
CP5 needs to be set to sequence 4
CP6 (start/finish) needs to be set to sequence 5
once you get them in order you'll be fine...
oh ya be sure all their object properties "type" is set to "checkpoint" also
[edit] more info on cp's