MTM2.com

hello

I have a problem with c-pod: I created my truck, I want to put it in file. pod but when I had pod created, there is every time a mistake saying:
Error number: 76
Error description: untraceable access path
Error source: CPOD

somebody can help me?

thanks

Do you have these folders?

\ART
\MODELS
\TRUCK

Make sure your ACT and RAW files are in the ART folder, and BIN files are in the MODELS folder and the TRK file is in the TRUCK folder.

Also, if you created a shortcut from the cpod menu, you cannot move the program. If you do, then you have to delete the shortcut and make it again.

If these do not fix the problem, can you tell us more about when it happens and what you do to get it?

yes I have these folders
all is has its room but there is always this mistake
I go in the open menu
I select create POD (*.TRK)
I select the file .TRK of my truck
that charges and next mark the mistake said higher
and when I save, it comes true but there is not anything in the file

Did you extract ALL the files from the truck2.pod ?


If yes, then we might have to wait to see what CH_2005 has to say.

yes I extracted everything but they must be activated?

From what you say, everything should work good.

There are two more things you can try.

1. save your art files, then delete everything and begin over (that is not too bad because you won't need to repaint anything).

2. send me your files and tell me which truck you used and I will try myself and see if the error happens for me too. You have my email address ;-)

ok thanks

I put files of my truck in downloading that is easier to spend to you them

The truck model was calling for these files. I don't know why. But when they were not found by c-pod that's when you got the error.

CIRCUIT1.RAW
CIRCUIT2.RAW

http://mtm2.com/~trucks/trucks.cgi?s=black+trophy

THANKS Phineus THANK YOU!!!!